Filter
Top Products
1294 CHAPTER 84: IPV6 OSPFV3 CONFIGURATION COMMANDS
area-id: The ID of an area, a decimal integer (in the range of 0 to 4294967295)
that is translated into IPv4 address format by the system or an IPv4 address.
Description Use the
display ospfv3 topology command to display OSPFv3 topology
information. If no process is specified, topology information of all OSPFv3
processes is displayed.
Examples # Display OSPFv3 area 1 topology information.
<Sysname> display ospfv3 topology area 1
OSPFv3 Process (1)
OSPFv3 Area (0.0.0.1) topology
Type ID(If-Index) Bits Metric Next-Hop Interface
Rtr 1.1.1.1 --
Rtr 2.2.2.2 1 2.2.2.2 Eth1/0
Rtr 3.3.3.3 1 3.3.3.3 Eth1/0
Rtr 4.4.4.4 1 4.4.4.4 Eth1/0
Net 4.4.4.4(983049) 1 0.0.0.0 Eth1/0
display ospfv3 vlink
Syntax display ospfv3 [ process-id ] vlink
View Any view
Parameters process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
Description Use the
display ospfv3 vlink command to display OSPFv3 virtual link
information. If no process is specified, virtual link information of all OSPFv3
processes is displayed.
Examples # Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Serial2/0, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Re
transmit: 5
Table 314 Description on the fields of the display ospfv3 topology command
Field Description
Type Type of node
ID(If-Index) Router ID
Bits Flag bit
Metric Cost value
Next-Hop Next hop
Interface Outbound interface