Filter
Top Products
1636 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS
Related command: mpls te retry.
Example # Set the interval for re-establishing tunnel 0 to 20 seconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te timer retry 20
mpls te tunnel-id
Syntax mpls te tunnel-id tunnel-id
View Tunnel interface view
Parameters tunnel-id: Tunnel ID. The value range and default vary by device.
Description Use the
mpls te tunnel-id command to configure the tunnel ID.
You need to configure the tunnel ID before issuing the mpls te commit command
for the first time. Otherwise, the tunnel cannot be created.
n
Once configured, a tunnel ID cannot be removed. To change a tunnel ID, you need
to remove the tunnel and then reconfigure the tunnel, giving it a new tunnel ID.
Examples # Configure the tunnel ID as 100.
<Sysname> system-view
[Sysname] interface tunnel 1/0/0
[Sysname-Tunnel1/0/0] mpls te tunnel-id 100
mpls te vpn-binding
Syntax mpls te vpn-binding { acl acl-number | vpn-instance vpn-instance-name }
undo mpls te vpn-binding
View Tunnel interface view
Parameter acl-number: Referenced ACL number, in the range 3000 to 3999. The MPLS TE
tunnel forwards only VPN instance traffic that matches the referenced ACL.
vpn-instance-name: VPN instance name, a string of 1 to 31 characters. The MPLS
TE tunnel forwards only traffic of the specified VPN instance.
Description Use the
mpls te vpn-binding command to define the traffic that can travel the
MPLS TE tunnel.
Use the
undo mpls te vpn-binding command to restore the default.
By default, no restriction is defined about what traffic can travel down a TE tunnel.