Filter
Top Products
320 CHAPTER 20: DCC CONFIGURATION COMMANDS
If you perform the dialer enable-circular command or its undo form on a
non-dial interface, do the same on the interface to recover it.
Related command: dialer circular-group.
Example # Enable C-DCC on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer enable-circular
dialer flow-interval
Syntax dialer flow-interval interval
undo dialer flow-interval
View System view
Parameter interval: Traffic statistics interval, in the range 1 to 1500 seconds.
Description Use the
dialer flow-interval command to configure the traffic statistics interval
for DCC.
Use the
undo dialer flow-interval command to restore the default.
By default, the traffic statistics interval for DCC is 20 seconds.
This command is only useful for traffic-triggered dial in DCC. For example, when
using traffic-triggered MP link bundling with DCC, you may need to configure
DCC to send traffic statistics about dialup links at certain intervals to MP.
Related command: dialer threshold.
Example # Set traffic statistics interval to three seconds for DCC.
<Sysname> system-view
[Sysname] dialer flow-interval 3
dialer isdn-leased (physical interface view)
Syntax dialer isdn-leased number
undo dialer isdn-leased number
View Dial interface (Physical interface) view
Parameter number: Number of the ISDN B channel for leased line connection. It ranges from
0 to 1 for a BRI interface, and 0 to 30 (with 15 excluded for the control channel)