Filter
Top Products
950 CHAPTER 71: IP ROUTING TABLE COMMANDS
load-bandwidth
Syntax load-bandwidth bandwidth
undo load-bandwidth
View Interface view
Parameters bandwidth: Specifies the load sharing bandwidth for the interface.
Description Use the
load-bandwidth bandwidth command to specify the load sharing
bandwidth of the interface.
Use the
undo load-bandwidth command to restore the default.
The load sharing bandwidth of an interface defaults to the physical bandwidth of
the interface.
Examples # Configure the load sharing bandwidth of the interface.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] load-bandwidth 100
reset load-sharing
Syntax reset load-sharing statistics ip address ip-address { mask | mask-length }
reset load-sharing statistics all
View User view
Parameters ip-address: Destination IP address, in dotted decimal notation.
mask: IP address mask, in dotted decimal notation.
mask-length:IP address mask length, in the range 0 to 32.
Description Use the
reset load-sharing ip address command to clear the statistics of
non-balanced load sharing. This command clears the load sharing statistics of all
the outbound interfaces corresponding to the destination IP address.
Use the
reset load-sharing all command to clear the load sharing statistics of
the outbound interfaces of all the forwarding entries.
Examples # Display the statistics of bandwidth-based load sharing.
<Sysname> display load-sharing ip address 10.2.1.0 24
There are/is totally 3 route entry(s) to the same destination network.
Nexthop Packet(s) Bandwidth[KB] Flow(s) Interface
10.1.1.2 763851 100000 0 Ethernet0/0/0