Filter
Top Products
1745
Related command: interface tunnel on page 884 and tunnel-protocol on page 887.
Example # Set the quiet period to 100 seconds for VAM client abc when the attempts for
tunneling the Hub reach the maximum value.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] dvpn session dumb-time 100
dvpn session idle-time
Syntax dvpn session idle-time time-interval
undo dvpn session idle-time
View Tunnel interface view
Parameter time-interval: Idle timeout for a Spoke-Spoke type DVPN tunnel in seconds, in the
range 60 to 1,800.
Description Use the
dvpn session idle-time command to configure the idle timeout of a
Spoke-Spoke type DVPN tunnel, that is, the tunnel will be removed automatically
if no data flows are transferred through a Spoke-Spoke type DVPN tunnel during
the idle timeout time.
Use the
undo dvpn session idle-time command to restore the default.
By default, the idle timeout for a Spoke-Spoke type DVPN tunnel is 300 seconds.
Note that all VAM clients in a VPN domain must have the same configuration.
Related command: interface tunnel on page 884 and tunnel-protocol on page 887.
Example # Set the idle timeout for a Spoke-Spoke type DVPN tunnel to 600 seconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-tunnel0] dvpn session idle-time 600
ipsec profile (tunnel interface view)
Syntax ipsec profile ipsec-profile-name&<1-6>
undo ipsec profile [ ipsec-profile-name&<1-6> ]
View Tunnel interface view
Parameter ipsec-profile-name&<1-6>: Name of the IPSec profile used for protecting data
packets and control packets passing through a DVPN tunnel, a case-insensitive