Filter
Top Products
2573
[Sysname-voice-line1/0] em-signal wink
[Sysname-voice-line1/0] delay send-wink 700
delay wink-hold
Syntax delay wink-hold milliseconds
undo delay wink-hold
View E&M voice subscriber line view
Parameter wink-hold milliseconds: Specifies duration (in milliseconds) the terminating side
sends wink signals in the wink start mode. The value ranges from 100 to 3,000.
Description Use the
delay wink-hold command to configure duration the terminating side
sends wink signals in the wink start mode.
Use the
undo delay wink-hold command to restore the default.
By default, the duration the terminating side sends wink signals is 500 milliseconds
in the wink start mode.
Related command: em-signal.
Example # Set the duration the terminating side sends wink signals in the wink start mode
to 700 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal wink
[Sysname-voice-line1/0] delay wink-hold 700
delay wink-rising
Syntax delay wink-rising milliseconds
undo delay wink-rising
View E&M voice subscriber line view
Parameter wink-rising milliseconds: Specifies the maximum amount of time (in milliseconds)
the originating side waits for a wink signal after sending a seizure signal in the
wink start mode. The value ranges from 100 to 5,000.
Description Use the
delay wink-rising command to configure a maximum amount of time
the originating side waits for a wink signal after sending a seizure signal in the
wink start mode.