Filter
Top Products
2461
Parameter minutes: Specifies timeout time in minutes, in the range 0 to 35791, defaulting to
10 minutes.
seconds: Specifies timeout time in seconds, in the range 0 to 59, defaulting to 0
seconds.
Description Use the
idle-timeout command to set the idle-timeout timer. When it expires,
the user connection is terminated.
Use the
undo idle-timeout command to restore the default.
The default idle-timeout is 10 minutes.
n
The system automatically terminates user’s connection if there is no information
interaction between the device and the user in timeout time.
Setting idle-timeout to zero disables the timer and the connection is maintained
whether it is idle or not.
Example # Set the idle-timeout timer to 1 minute and 30 seconds.
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] idle-timeout 1 30
lock
Syntax lock
View User view
Parameter None
Description Use the
lock command to set a password to prevent unauthorized users from
operating under the active user interface.
After entering the lock command, you are prompted to input a password (up to
16 characters) and then confirm it by inputting the password again. The password
is successfully set only when you input the exact password during the
confirmation. After setting the password, you will be required to input the
password next time you enter the system.
By default, this function is disabled.
Example # Lock the active user interface.
<Sysname> lock
Please input password<1 to 16> to lock current user terminal interface:
Password:
Again: