Filter
Top Products
2237
147
VRRP CONFIGURATION COMMANDS
FOR IPV6
display vrrp ipv6
Syntax display vrrp ipv6 [ verbose ] [ interface interface-type interface-number [ vrid
virtual-router-id ]]
View Any view
Parameter verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the
specified interface. interface-type interface-number specifies an interface by its
type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to
255.
Description Use the
display vrrp ipv6 command to display the state information of VRRP for
IPv6.
If you do not specify verbose, only the brief state information of VRRP is
displayed.
If you specify both interface and standby group, only the state information of the
specified standby group is displayed; if you only specify an interface, the state
information of all the standby groups on the interface is displayed; if you specify
neither, the state information of all the standby groups on the device is displayed.
Example # Display brief information about all VRRP standby groups on the device for IPv6.
<Sysname> display vrrp ipv6
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
The total number of the virtual routers: 1
Interface VRID State Run Adver. Auth Virtual
Pri Time Type IP
---------------------------------------------------------------------
Eth1/0 1 Master 100 100 NONE FE80::1
# Display detailed information about all standby groups on the device.