Filter
Top Products
2380 CHAPTER 158: FTP CLIENT CONFIGURATION COMMANDS
FTP. If no primary IP address is configured on the source interface, the connection
fails.
ip source-ip-address: Source IP address of the FTP connection. It must be an IP
address configured on the device.
Description Use the
ftp client source command to configure the source address of the
transmitted FTP packets from the FTP client.
Use the
undo telnet client source command to restore the default.
By default, a device uses the IP address of the interface determined by the routing
protocol as the source IP address to communicate with an FTP server.
Note that:
■ The source address includes the source interface and the source IP address. If
you use the ftp client source command to specify the source interface and the
source IP address, the newly specified source IP address overwrites the original
one and vice versa.
■ If the source address is specified with the ftp client source command and
then with the ftp command, the source address specified with the latter one is
used to communicate with the FTP server.
■ The source address specified with the ftp client source command is valid for
all ftp connections and the source address specified with the ftp command is
valid only for the current ftp connection.
Related command: display ftp client configuration.
Example # Specify the source IP address of the FTP client as 2.2.2.2.
<Sysname> system-view
[Sysname] ftp client source ip 2.2.2.2
# Specify the source interface of the FTP client as Ethernet1/0.
<Sysname> system-view
[Sysname] ftp client source interface ethernet 1/0
ftp ipv6
Syntax ftp ipv6 [ server-address [ service-port ] [ source ipv6 source-ipv6-address ] [ -i
interface-type interface-number ]]
View User view
Parameter server-address: IP address or host name of the remote FTP server.
service-port: Port number of the FTP server, in the range 0 to 65535. The default
value is 21.