Filter
Top Products
1
PUBLIC AT M AND DSL INTERFACE
COMMANDS
display interface atm
Syntax display interface atm [ interface-number ]
View Any view
Parameter interface-number: Interface number. If no interface is specified, the configuration
and status information about all ATM/DSL interfaces and channels on them is
displayed.
Description Use the
display interface atm command to display the configuration and status
information about an ATM interface or a DSL interface.
If no interface is specified, this command displays the configuration and status
information about all ATM interfaces and DSL interfaces.
Example # Display the configuration and state information about interface ATM 2/0.
<Sysname> display interface atm 2/0
Atm2/0 current state :DOWN
Line protocol current state :DOWN
Description : Atm2/0 Interface
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
AAL enabled: AAL5, Maximum VCs: 128
Current VCs: 0 (0 on main interface)
ATM over E1, Scramble enabled, frame-format crc4-adm
code hdb3, clock slave,Cable-length long, loopback not set
Cable type: 75 ohm non-balanced
Line Alarm: LOS LOF
Line Error: 0 FERR, 0 LCV, 0 CERR, 0 FEBE
Last 0 seconds input rate 0.00 bytes/sec, 0.00 packets/sec
Last 0 seconds output rate 0.00 bytes/sec, 0.00 packets/sec
Input : 0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants,
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns,0 no buffer
Output: 0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns