Filter
Top Products
1302 CHAPTER 84: IPV6 OSPFV3 CONFIGURATION COMMANDS
View Interface view
Parameters seconds: Dead time in seconds, ranging from 1 to 65535,
instance-id: The instance ID of an interface, in the range of 0 to 255, which
defaults to 0.
Description Use the
ospfv3 timer dead command to configure the OSPFv3 neighbor dead
time for an interface that belongs to a specified instance.
Use the
undo ospfv3 timer dead command to restore the default.
By default, the OSPFv3 neighbor dead time is 40 seconds for P2P and Broadcast
interfaces, and is not supported on P2MP and NBMA interfaces at present.
OSPFv3 neighbor dead time: if an interface receives no hello packet from a
neighbor after dead time elapses, the interface will considers the neighbor is dead.
The dead seconds value is at least four times the Hello seconds value and must be
identical on interfaces attached to the same network segment.
Related commands: ospfv3 timer hello.
Examples # Configure the OSPFv3 neighbor dead time as 80 seconds for an interface with
instance 1.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ospfv3 timer dead 80 instance 1
ospfv3 timer hello
Syntax ospfv3 timer hello seconds [ instance instance-id ]
undo ospfv3 timer hello [ instance instance-id ]
View Interface view
Parameters seconds: Interval between hello packets, ranging from 1 to 65535.
instance-id: The instance ID of an interface, in the range of 0 to 255, which
defaults to 0.
Description Use the
ospfv3 timer hello command to configure the hello interval for an
interface that belongs to an instance.
Use the
undo ospfv3 timer hello command to restore the default.
By default, the hello interval is 10 seconds for P2P and Broadcast interfaces, and is
not supported on the P2MP or NBMA interfaces at present.