Filter
Top Products
166 CHAPTER 8: GENERAL ETHERNET INTERFACE CONFIGURATION COMMANDS
# Display the current state of Layer 2 interface Ethernet1/0 and related
information.
<Sysname> display interface ethernet 1/0
Ethernet1/0 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e200-8048
Description: Ethernet1/0 Interface
Loopback is not set
Media type is twisted pair, port hardware type is 100_BASE_TX
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1536
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
PVID: 100
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 100
Port priority: 0
Last 300 seconds input: 6 packets/sec 678 bytes/sec 20%
Last 300 seconds output: 1 packets/sec 179 bytes/sec 17%
Input (total): 61745144 packets, 12152212250 bytes
47519150 broadcasts, 12121681 multicasts
Input (normal): 61745144 packets, - bytes
47519150 broadcasts, 12121681 multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 1395522 packets, 183608303 bytes
13 broadcasts, 1273860 multicasts, 0 pauses
Output (normal): 1395522 packets, - bytes
13 broadcasts, 1273860 multicasts, 0 pauses
Output: 0 output errors, - underruns, 1 buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Output queue (FIFO queuing :
Size/Length/Discards)
Output queue (current message number in
the FIFO queue/ maximum number of
messages allowed in the FIFO
queue/number of discarded messages)
Last 300 seconds input rate Average input rate over the last 300
seconds
Last 300 seconds output rate Average output rate over the last 300
seconds
Input Input packets
Output Output packets
Table 12 Description on the fields of the display interface command (in bridge mode)
Field Description
Ethernet1/0 current state Current physical link state of the Ethernet interface
IP Packet Frame Type Frame type of the Ethernet interface
Hardware address Hardware address
Description Description of the interface
Loopback is not set Loopback is not configured
Table 11 Description on the fields of the display interface (in route mode) command.
Field Description