Filter
Top Products
148 CHAPTER 6: ADSL INTERFACE CONFIGURATION COMMANDS
Current Rate(kbps): 0 0
Latency: Intl Intl
display dsl version
Syntax display dsl version interface atm interface-number
View Any view
Parameter interface-number: Specifies a DSL interface to view the version and support
capability information on it.
Description Use the
display dsl version command to display the DSL version and support
capabilities of an interface.
Example # Display the ADSL version information of interface ATM 2/0.
<Sysname> display dsl version interface atm 2/0
Adsl board chipset and version info:
Table 5 Description on the fields of the display dsl status command
Field Description
Line Status Line status of the ADSL interface, which can be:
■ No Defect, indicating the normal state
■ Loss Of Frame, indicating an error concerning frame
■ Loss Of Signal, indicating an error concerning signal
■ Loss Of Power, indicating an error concerning power supply
■ Loss Of Signal Quality, indicating an error concerning signal quality
■ Unknown, indicating an unknown error
Training Status Training status of the ADSL interface, which can be:
■ Idle, indicating the interface is idle
■ G.994 Training, indicating a G.994 training
■ G.992 Started, indicating a G.992 training is launched
■ G.922 Channel Analysis, indicating G.922 channel analysis is going on
■ G.992 Message Exchange, indicating G.992 message exchange is
going on
■ Showtime, indicating normal data exchange
■ Unknown
The following information appears after the line is activated.
Active Params
■ Standard, connection standard adopted by the interface and the
DSLAM
■ SNR, signal-to-noise ration of the ADSL link
■ Attr, attenuation of the ADSL link
■ Pwr, transmit power of the ADSL module, in dbm
■ Current Rate, uplink/downlink rate between the ADSL interface and
the DSLAM, in kbps
■ Latency, Way in which the interface and the DSLAM are connected,
which can be “Intl” (cross-over) and “Fast”