Filter
Top Products
165
MAC ADDRESS TABLE MANAGEMENT
CONFIGURATION COMMANDS
n
Interfaces that MAC address table management involves can only be Layer 2
Ethernet interfaces.
display mac-address
Syntax display mac-address blackhole [ vlan vlan-id ] [ count ]
display mac-address [ mac-address [ vlan vlan-id ] | [ dynamic | static ] [ interface
interface-type interface-number ] [ vlan vlan-id ] [ count ]]
View Any view
Parameter blackhole: Displays blackhole MAC address entries. These entries do not age but
you can add or remove them. The packets whose destination MAC addresses
match blackhole MAC address entries are dropped.
vlan vlan-id: Displays MAC address entries of the specified VLAN, where vlan-id is
in the range 1 to 4094.
count: Displays the total number of MAC addresses in the MAC address table.
mac-address: Specifies a MAC address in the format of H-H-H.
dynamic: Displays dynamic MAC address entries. Aging time is set for these
entries.
static: Displays static MAC address entries. Similar to blackhole MAC address
entries, these entries do not age but you can add or remove them.
interface interface-type interface-number: Displays the MAC address entry of a
specified interface, where interface-type interface-number specifies an interface
by its type and number.
Description Use the
display mac-address command to display information about the MAC
address table.
Related commands: mac-address (system view), mac-address (Ethernet interface view),
mac-address timer.
Example # Display the MAC address table entry for MAC address 00e0-fc01-0101.