Filter
Top Products
2544 CHAPTER 172: IPX CONFIGURATION COMMANDS
Description Use the ipx route load-balance-path command to specify the maximum
number of equivalent routes to the same destination.
Use the
undo ipx route load-balance-path command to restore the default.
The default is 1.
This number is the maximum active equivalent route number of the system. If a
newly configured number is smaller than the previous, the system will change the
excessive active routes to inactive routes.
Example # Specify the maximum equivalent route number to the same destination address
as 30.
<Sysname> system-view
[Sysname] ipx route load-balance-path 30
ipx route max-reserve-path
Syntax ipx route max-reserve-path paths
undo ipx route max-reserve-path
View System view
Parameter paths: Maximum number of routes to the same destination, including both static
and dynamic routes, in the range 1 to 255.
Description Use the
ipx route max-reserve-path command to specify the maximum
number of routes to the same destination.
Use the
undo ipx route max-reserve-path command to restore the default.
By default, the value is 4.
When the route number to the same destination address exceeds the maximum
value configured, the newly found dynamic routes will not be added into the
routing table, but discarded directly. If the newly configured value is less than the
original one, the excessive routes in the current routing table will not be deleted
until they get aged out or are deleted manually.
Example # Specify the maximum number of routes to the same destination to 200.
<Sysname> system-view
[Sysname] ipx route max-reserve-path 200
ipx sap disable
Syntax ipx sap disable
undo ipx sap disable