Filter
Top Products
2440 CHAPTER 163: INFORMATION CENTER CONFIGURATION COMMANDS
Use the undo info-center snmp channel command to restore the default
channel to output system information to the SNMP NMS.
By default, output of system information to the SNMP NMS is enabled with a
default channel name of snmpagent and a default channel number of 5.
For more information, refer to the display snmp-agent commands in “SNMP
Configuration Commands” on page 2329.
Example # Set to output system information to the SNMP NMS through channel 6.
<Sysname> system-view
[Sysname] info-center snmp channel 6
info-center source
Syntax info-center source { module-name | default } channel { channel-number |
channel-name } [ debug { level severity | state state } * | log { level severity | state
state } * | trap { level severity | state state } * ] *
undo info-center source { module-name | default } channel { channel-number |
channel-name }
View System view
Parameter module-name: Specifies the output rules of the system information of the
specified modules, which vary with devices. For instance, if information on ARP
module is to be output, you can configure this argument as ARP.
default: Specifies the output rules of the system information of all the modules
allowed to output the system information. This configuration varies with devices.
debug: Debug information.
log: Log information.
trap: Trap information.
level severity: Specifies the severity of system information, refer to Table 627 for
details.
state state: Specifies the state of system information, which could be on or off.
channel-
number: Specifies a channel number, in the range of 0 to 9.
channel-name: Specifies a channel name, which could be a default name or one
that is defined by the user. The user needs to specify a channel name first before
using it as a self-defined channel name. For more information, refer to
“info-center channel name” on page 2432.
Description Use the
info-center source command to specify the output rules of the system
information.