Filter
Top Products
504 CHAPTER 31: PPP AND MP CONFIGURATION COMMANDS
display interface virtual-template
Syntax display interface virtual-template [ number ]
View Any view
Parameter number: Virtual template (VT) number, which can be the number of any existing
VT.
Description Use the
display interface virtual-template command to view the information
about a VT. If you do not provide the number argument, this command will display
the information about all the existing VTs.
Related command: interface virtual-template.
Example # View the information about VT 1.
<Sysname> display interface virtual-template 1
Virtual-Template1 current state: UP
Line protocol current state: UP (spoofing)
Description: Virtual-Template1 Interface
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is None
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Refer to Table 82 for the description on the other fields.
LCP initial Link control protocol (LCP) negotiation is complete
Physical Physical type of the interface
Last 300 seconds input: 0 bytes/sec
0 packets/sec
Last 300 seconds output: 0 bytes/sec
0 packets/sec
Average rate of input packets and output packets in the
last 300 seconds (in bps)
0 packets input, 0 bytes, 0 drops Total amount of input packets of the interface (in the
number of packets and in bytes respectively), and the
number of dropped packets within the input packets
0 packets output, 0 bytes, 0 drops Total amount of output packets of the interface (in the
number of packets and in bytes respectively), and the
number of dropped packets within these output
packets
Table 82 Description on the fields of the display interface mp-group command
Field Description