Filter
Top Products
1988 CHAPTER 129: HWTACACS CONFIGURATION COMMANDS
Use the undo timer realtime-accounting command to restore the default.
Note that:
■ For real-time accounting, a NAS must transmit the accounting information of
online users to the HWTACACS accounting server periodically. This command is
for setting the interval.
■ The setting of the real-time accounting interval somewhat depends on the
performance of the NAS and the HWTACACS server: a shorter interval requires
higher performance. You are therefore recommended to adopt a longer
interval when there are a large number of users (more than 1000, inclusive).
The following table lists the recommended ratios of the interval to the number
of users.
Example # Set the real-time accounting interval to 51 minutes for HWTACACS scheme
hwt1.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer realtime-accounting 51
timer response-timeout (HWTACACS scheme view)
Syntax timer response-timeout seconds
undo timer response-timeout
View HWTACACS scheme view
Parameter seconds: HWTACACS server response timeout period in seconds. It ranges from 1
to 300 and defaults to 5.
Description Use the
timer response-timeout command to set the HWTACACS server
response timeout timer.
Use the
undo timer command to restore the default.
As HWTACACS is based on TCP, the timeout of the server response timeout timer
and/or the TCP timeout timer will cause the device to be disconnected from the
HWTACACS server.
Related command: display hwtacacs.
Table 514 Recommended ratios of the accounting interval to the number of users
Number of users Real-time accounting interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
1000 or more 15 or more