Filter
Top Products
2074 CHAPTER 135: PORTAL CONFIGURATION COMMANDS
000d-88f8-0eab 2.2.2.2 0 Ethernet1/0
Total 1 user(s) matched, 1 listed.
portal auth-network
Syntax portal auth-network network-address { mask-length | mask }
undo portal auth-network { network-address | all }
View Interface view
Parameter network-address: Authentication subnet address.
mask-length: Length of the subnet mask, in the range of 0 to 32.
mask: Subnet mask, in dotted decimal notation.
all: Specifies all authentication subnets.
Description Use the
portal auth-network command to configure a portal authentication
subnet.
Use the
undo portal auth-network command to remove the configuration.
Note that this command is applicable to only Layer 3 authentication. The portal
authentication subnet for direct authentication is any source IP address, and the
portal authentication subnet for re-DHCP authentication is the one determined by
the private IP address of the interface.
By default, the portal authentication subnet is 0.0.0.0/0, meaning to authenticate
users in all subnets.
Example # Set the portal authentication subnet to 10.10.10.0/24.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] portal auth-network 10.10.10.0 24
Table 543 Description on the fields of the display portal user command
Field Description
Index Index of a portal user
State Current state of a portal user
SubState Current sub-state of a portal user
MAC MAC address of a portal user
IP IP address of a portal user
Vlan VLAN where a portal user is
Interface Interface to which a portal user is attached
Total 1 user(s) matched, 1 listed Counts of portal users