Filter
Top Products
1156 CHAPTER 76: OSPF CONFIGURATION COMMANDS
undo snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt
| ifstatechange | iftxretransmit | lsdbapproachoverflow | lsdboverflow | maxagelsa |
nbrstatechange | originatelsa | vifcfgerror | virifauthfail | virifrxbadpkt |
virifstatechange | viriftxretransmit | virnbrstatechange ] *
View System view
Parameters process-id: OSPF process ID, in the range 1 to 65535.
ifauthfail: Interface authentication failure information.
ifcfgerror: Interface configuration error information.
ifrxbadpkt: Information about error packets received.
ifstatechange: Interface state change information.
iftxretransmit: Packet receiving and forwarding information.
lsdbapproachoverflow: Information about cases approaching LSDB overflow.
lsdboverflow: LSDB overflow information.
maxagelsa: LSA max age information.
nbrstatechange: Neighbor state change information.
originatelsa: Information about LSAs originated locally.
vifauthfail: Virtual interface authentication failure information.
vifcfgerror: Virtual interface configuration error information.
virifauthfail: Virtual interface authentication failure information.
virifrxbadpkt: Information about error packets received by virtual interfaces.
virifstatechange: Virtual interface state change information.
viriftxretransmit: Virtual interface packet retransmit information.
virnbrstatechange: Virtual interface neighbor state change information.
Description Use the
snmp-agent trap enable ospf command to enable the sending of
SNMP traps for a specified OSPF process. If no process is specified, the feature is
enabled for all processes.
Use the
undo snmp-agent trap enable ospf command to disable the feature.
By default, this feature is enabled.
Refer to “SNMP Configuration Commands” on page 2329 for related
information.