Filter
Top Products
2128 CHAPTER 140: IPSEC CONFIGURATION COMMANDS
<Sysname> display ipsec session tunnel-id 5
------------------------------------------------------------
total sessions : 1
------------------------------------------------------------
tunnel-id : 5
session idle duration/total duration (sec) : 30/300
session flow : (4 times matched)
Sour Addr : 12.12.12.2 Sour Port: 0 Protocol : 1
Dest Addr : 13.13.13.2 Dest Port: 0 Protocol : 1
display ipsec statistics
Syntax display ipsec statistics
View Any view
Parameter None
Description Use the
display ipsec statistics command to display IPSec packet statistics.
Related command: reset ipsec statistics.
Example # Display IPSec packet statistics.
<Sysname> display ipsec statistics
the security packet statistics:
input/output security packets: 5124/8231
input/output security bytes: 52348/64356
input/output dropped security packets: 0/0
dropped security packet detail:
not enough memory: 0
can’t find SA: 0
queue is full: 0
authentication has failed: 0
wrong length: 0
Table 566 Description on the fields of the display ipsec session command
Field Description
total sessions Total number of IPSec sessions
tunnel-id IPSec tunnel ID, same as the connection-id of the IPSec SA
session idle time Idle duration of the IPSec session in seconds
total duration Total duration of the IPSec session in seconds, defaulted to 300
seconds
session flow Flow information of the IPSec session
times matched Total number of packets matching the IPSec session
Sour Addr Source IP address of the IPSec session
Dest Addr Destination IP address of the IPSec session
Sour Port Source port number of the IPSec session
Dest Port Destination port number of the IPSec session
Protocol Protocol number of the IPSec protected data flow, for example, 1 for
ICMP