Filter
Top Products
2696 CHAPTER 177: H.323 CONFIGURATION COMMANDS
undo gw-address
View Gatekeeper client view
Parameter ip-address: Source IP address to be bound to the voice gateway.
Description Use the
gw-address command to bind a source IP address with the voice
gateway.
Use the
undo gw-address command to remove the binding.
By default, no source IP address is bound to the voice gateway.
c
CAUTION:
■ Use this command before configuring the ras-on command. In case the latter
has been configured, undo it first.
■ To make calls successfully, ensure that the source IP address is a valid IP address
already assigned to an Ethernet or loopback interface on the device, and in
addition, this address and the address of the peer H.323 entity (a gatekeeper,
terminal, or MCU) are reachable to each other.
Related command: area-id, gk-2nd-id, gk-id, gw-address, and ras-on.
Example # Bind the source IP address 1.1.1.1 to the voice gateway.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] gk-client
[Sysname-voice-gk] gw-address 1.1.1.1
gw-id
Syntax gw-id namestring
undo gw-id
View Gatekeeper client view
Parameter namestring: Gateway alias (gateway identifier), a string of 1 to 128 case-sensitive
characters.
Description Use the
gw-id command to assign an alias to the gateway. This alias overwrites
the old one, if any.
Use the
undo gw-id command to remove the alias.
By default, no alias is assigned to the gateway.
Note that each gateway can be assigned only one alias. It is used by the
gatekeeper to identify the gateway.