Filter
Top Products
2726 CHAPTER 180: VOICE RADIUS CONFIGURATION COMMANDS
With this function enabled, called numbers will be sent to the RADIUS server for
authorization after users who dial some access number to make IP calls pass
authentication.
You must enable the authentication function (by using the authentication
command) before the authorization function. Otherwise, the authorization
command is unavailable.
Related command: gw-access-number and authentication.
Example # Enable the authorization function for users who dial the access number 17909.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] gw-access-number 17909
[Sysname-voice-dial-anum17909] authentication
[Sysname-voice-dial-anum17909] authorization
# Disable the authorization function for users who dial the access number 17909.
[Sysname-voice-dial-anum17909] undo authorization
authorization-did
Syntax authorization-did
undo authorization-did
View Voice AAA client view
Parameter None
Description Use the
authorization-did command to enable the authentication function for
all one-stage dialing users.
Use the
undo authorization-did command to disable the authorization
function for all one-stage dialing users.
By default, the authorization function is disabled for all one-stage dialing users.
This command is applicable to only one-stage dialing users, instead of two-stage
dialing users. With this function enabled, called numbers will be sent to the
RADIUS server for authorization after users who dial some access number to make
IP calls pass authentication.
You must enable the authentication function before the authorization function.
Otherwise, the authorization-did command is unavailable.
Related command: authentication-did.