Filter
Top Products
568 CHAPTER 37: ISDN CONFIGURATION COMMANDS
T321 30
T322 4
display isdn spid
Syntax display isdn spid [ interface interface-type interface-number ]
View Any view
Parameter interface-type interface-number: Specifies an interface by its type and number.
Description Use the
display isdn spid command to view information on SPID on the BRI
interface encapsulated with the NI protocol.
You may execute this command to view the SPID type, SPID value and some other
information when ISDN is running. Executing this command without specifying an
interface, you may view information on SPI on all the SPID-supported BRI
interfaces.
Example # Display the related information of SPID on the NI-supported interface BRI 1/0.
<Sysname> display isdn spid interface bri 1/0
Interface Bri1/0 :
SPID Type: AUTO
SPID B1:
SPID Num:
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID B2:
SPID Num:
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
Table 97 Description of the fields of the display isdn parameters command
Item Description
T200(sec) Retransmit-timer (in seconds) of the L2 protocol of ISDN
T201(sec) TEI test request retransmit-timer (in seconds) of the L2 protocol of
ISDN
T202(sec) TEI request retransmit-timer (in seconds) of the ISDN L2 protocol
T203(sec) The maximum link idle time (in seconds) of the ISDN L2 protocol
N200 The maximum number of retransmissions
K(BRI) The maximum number of unacknowledged frames (slide window
size) on the ISDN BRI port
K(PRI) The maximum number of unacknowledged frames (slide window
size) on the ISDN PRI port
Timer-Number ISDN L3 timer
Value(sec) Duration (in seconds) of each ISDN L3 timer