Filter
Top Products
640 CHAPTER 40: PORT-BASED VLAN CONFIGURATION COMMANDS
Description Use the port access vlan command to add the current Access port to a specified
VLAN.
Use the
undo port access vlan command to add the current Access port to the
default VLAN.
Configured in Ethernet interface view, the setting is effective on the current port
only; configured in port group view, the setting is effective on all ports in the port
group. Make sure that the VLAN identified by the vlan-id argument exists before
issuing the port access vlan command.
Refer to “Link Aggregation Configuration Commands” on page 473 for
information about port groups.
Example # Add Ethernet 1/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] port access vlan 3
port hybrid pvid vlan
Syntax port hybrid pvid vlan vlan-id
undo port hybrid pvid
View Ethernet interface view, port group view
Parameter vlan-id : VLAN ID, in the range 1 to 4094.
Description Use the
port hybrid pvid vlan command to configure the default VLAN ID of
the Hybrid port.
Use the
undo port hybrid pvid command to restore the default, VLAN 1.
Execution of the undo vlan command on a Hybrid port to remove the default
VLAN does not affect the default VLAN configuration. That is to say, the
non-existent VLAN can still be the default VLAN.
Configured in Ethernet interface view, the setting is effective on the current port
only; configured in port group view, the setting is effective on all ports in the port
group.
Refer to “Link Aggregation Configuration Commands” on page 473 for
information about port groups.
The default VLAN ID of local Hybrid port must be consistent with that of the peer;
otherwise, packets cannot be forwarded properly.
Related command: port link-type.