Filter
Top Products
920 CHAPTER 70: TERMINAL ACCESS CONFIGURATION COMMANDS
By default, no hotkey is configured for connectivity test.
With the terminal connectivity test hotkey configured on the router, you can press
the hotkey to test the TCP connectivity between the terminal and the router and
that between the terminal and the FEP.
n
■ This command takes effect only in Telnet terminal access and TTY terminal
access.
■ The ASCII value of the hotkey configured must be different from that of any
other hotkey configured on the device. Otherwise, hotkey conflicts will occur.
For example, the hotkey value cannot be set to 17 or 19 because these two
values are used for the hotkeys of flow control.
■ Using the hotkey may not get a response rapidly when the terminal displays
too much data.
Example # Configure the terminal connectivity test hotkey as <Alt+A>, namely, 1 96 13.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] testkey 1 96 13
update changed-config
Syntax update changed-config
View Terminal template view
Parameters None
Description Use the
update changed-config command to update template configurations.
If the template has been applied on the corresponding interface, the
configurations made in template view will take effect after the update
changed-config command is executed. You are recommended to complete all
terminal template configurations before applying the template on the interface.
Note that some configurations, such as source IP address configuration and
encryption, take effect only after they are updated and the connection is
reestablished.
Example # Set the menu hotkey under the template and update the configuration for the
hotkey to take effect.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] menu hotkey 1
[Sysname-rta-template-abc] update changed-config