Filter
Top Products
1641
Description Use the static-cr-lsp ingress command to configure a static CR-LSP at the
ingress node.
Use the
undo static-cr-lsp ingress command to remove the static CR-LSP.
n
The next hop address cannot be a local public address when configuring the static
CR-LSP on the ingress or a transit node.
Example # Configure a static CR-LSP on the ingress node, setting its name to Tunnel3,
destination IP address to 202.25.38.1, destination address mask length to 24, next
hop IP address to 202.55.25.33, outgoing label to 237, and required bandwidth
to 20 kbps.
<Sysname> system-view
[Sysname] static-cr-lsp ingress Tunnel3 destination 202.25.38.1 next
hop 202.55.25.33 out-label 237 bandwidth 20
static-cr-lsp transit
Syntax static-cr-lsp transit tunnel-name incoming-interface interface-type interface-number
in-label in-label-value { nexthop next-hop-addr | outgoing-interface interface-type
interface-number } out-label out-label-value [ bandwidth [ bc0 | bc1 ]
bandwidth-value ]
undo static-cr-lsp transit tunnel-name
View System view
Parameter Tunnel-name: Tunnel name comprising 1 to 15 characters.
next-hop-addr: Next hop address.
outgoing-interface interface-type interface-number: Specifies an outgoing
interface for the static CR-LSP.
in-label-value: Incoming label, in the range 16 to 1023.
out-label-value: Outgoing label, in the range 16 to 1023.
bc0: Obtains bandwidth from a subpool.
bc1: Obtains bandwidth from the global pool.
bandwidth-value: Bandwidth assigned to the CR-LSP, in the range 1 to 32000000
kbps.
Description Use the
static-cr-lsp transit command to configure a static CR-LSP on a transit
node.
Use the
undo static-cr-lsp transit command to remove the static CR-LSP.