Filter
Top Products
2597
Use the undo hookoff-mode command to remove the binding.
By default, no FXS voice subscriber line is bound to the FXO voice subscriber line.
After an FXS voice subscriber line is bound to the FXO voice subscriber line, the
off-hook/on-hook state of these two lines will be consistent.
n
■ To keep the consistent off-hook/on-hook state between the bound FXS and
FXO voice subscriber lines, you must consider the configurations of the
private-line and caller-permit commands when executing the
hookoff-mode delay bind fxs_subscriber_line command. The FXS voice
subscriber line specified by fxs_subscriber_line must be the one to which the
dedicated line number points. In addition, only the bound FXS voice subscriber
line is allowed to originate calls to the FXO voice subscriber line by restricting
incoming calls.
■ The bound FXS and FXO voice subscriber lines must come from the same
device.
Example # Specify the delay off-hook mode for the FXO voice subscriber line and bind FXS
voice subscriber line 1/24 to the FXO voice subscriber line.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-subscriber-line 1/0] hookoff-mode delay bind 1/24
hookoff-time
Syntax hookoff-time time
undo hookoff-time
View Analog FXO voice subscriber line view
Parameter time: Length of the on-hook timer in seconds, in the range of 60 to 36,000.
Description Use the
hookoff-time command to configure the on-hook timer length.
Use the
undo hookoff-time command to restore the default on-hook timer
length.
By default, no on-hook timer length is set.
Example # Set the on-hook timer length to 500 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] hookoff-time 500