Filter
Top Products
146
IPV4-BASED VRRP CONFIGURATION
COMMANDS
n
The interfaces that VRRP involves can only be Layer 3 Ethernet interfaces and
VLAN interfaces unless otherwise specified.
display vrrp
Syntax display vrrp [ verbose ] [ interface interface-type interface-number [ vrid
virtual-router-id ]]
View Any view
Parameter verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the
specified interface. interface-type interface-number specifies an interface by its
type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to
255.
Description Use the
display vrrp command to display the state information of VRRP.
If you do not specify verbose, only the brief state information of VRRP is
displayed.
If you specify both interface and standby group, only the state information of the
specified standby group is displayed; if you only specify an interface, the state
information of all the standby groups on the interface is displayed; if you specify
neither, the state information of all the standby groups on the device is displayed.
Example # Display brief information about all standby groups on the device before a virtual
VRRP standby group is created.
<Sysname> display vrrp
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
The total number of the virtual outers: 1
Interface VRID State Run Adver. Auth Virtual
Pri Time Type IP
---------------------------------------------------------------------
Eth1/0 1 Master 100 1 NONE 10.10.10.2
# Display detailed information about all standby groups on the device.