Filter
Top Products
513
If a PC is connected to the device using PPP, you can use the winipcfg command
or the ipconfig/all command to view its DNS server address assigned by the
device.
A sysname device can provide a primary DNS server address and a secondary DNS
server address.
Example # Configure the local device to assign primary DNS server address 100.1.1.1, and
secondary DNS server address 100.1.1.2 to its peer.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] ppp ipcp dns 100.1.1.1 100.1.1.2
ppp ipcp dns admit-any
Syntax ppp ipcp dns admit-any
undo ppp ipcp dns admit-any
View Interface view
Parameter None
Description Use the
ppp ipcp dns admit-any command to configure the device to passively
accept the DNS server address assigned by the peer, even without sending a DNS
request.
Use the
undo ppp ipcp dns admit-any command to disable this function.
By default, a device does not passively accept DNS server address assigned by the
peer.
When a device is connected to another device (for example, a network access
server of a service provider) using PPP, the device can be configured to accept the
DNS server address allocated by the peer to resolute the domain name.
Example # Set the interface Serial 1/0 of the local device to accept DNS server address
allocated by the peer.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] ppp ipcp dns admit-any
ppp ipcp dns request
Syntax ppp ipcp dns request
undo ppp ipcp dns request
View Interface view