Filter
Top Products
1165
display rip interface
Syntax display rip process-id interface [ interface-type interface-number ]
View Any view
Parameters process-id: RIP process number, in the range of 1 to 65535.
interface-type interface-number: Specifies an interface.
Description Use the
display rip interface command to display the RIP interface information
of the RIP process.
If no interface is specified, information about all RIP interfaces of the RIP process is
displayed.
Examples # Display all the interface information of RIP process 1.
<Sysname> display rip 1 interface
Interface-name: Ethernet1/0
Address/Mask:1.1.1.1/24 MetricIn/Out:0/1 Version: RIPv1
Split-horizon/Poison-reverse:on/off Input/Output:on/on
Current packets number/Maximum packets number: 234/2000
display rip route
Syntax display rip process-id route [ statistics | ip-address { mask | mask-length } | peer
ip-address ]
View Any view
Parameters process-id: RIP process number, in the range of 1 to 65535.
Table 280 Description on the fields of the display rip interface command
Field
Description
Interface-name The name of an interface running RIP.
Address/Mask The IP address and Mask of the interface.
MetricIn/Out Additional routing metric added to the incoming and outgoing
routes
Version RIP version running on the interface
Split-horizon Indicates whether the split-horizon is enabled (ON: enabled, OFF:
disabled).
Poison-reverse Indicates whether the poison-reverse is enabled (ON: enabled,
OFF: disabled)
Input/Output Indicates if the interface is allowed to receiving (Input) or sending
(Output) RIP messages (on is allowed, off is not allowed).
Current packets
number/Maximum packets
number
Packets to be sent/Maximum packets that can be sent on the
interface