Filter
Top Products
132 CHAPTER 5: G.SHDSL INTERFACE CONFIGURATION COMMANDS
display dsl configuration
Syntax display dsl configuration interface atm interface-number
View Any view
Parameter interface-number: Specifies a iG.SHDSL interface to view the configuration
information about.
Description Use the
display dsl configuration command to display actual GSHDSL
configurations.
Example # Display the actual configurations of G.SHDSL interface ATM 3/0.
<Sysname> display dsl configuration interface atm 3/0
GSHDSL line parameter and mode Configuration
Mode: CPE
Standard: G.991.2
Annex: B
Wire Type: 2
Framing: 3
Line Rate: Auto Adaptive
Current Margin: 2
SNEXT margin: 0
Psd Mode: Sym PSD
LinkCheck: Disable
--Actual Handshake Status --
00: 0002 0000 0000 0000 0000 0000 0000 0000 0000 0000
10: 0000 0008 0000 0000 0000 0000 0000 0000 0008 0000
20: 0000 0000 0002 0002 0004 0010
--Local Handshake Status --
00: 0002 0001 0000 0000 0000 0000 0034 003f 003f 003f
10: 003f 003f 0003 0034 003f 003f 003f 003f 003f 0003
20: 0000 0000 0003 0003 000f 0010
--Remote Handshake Status --
00: 0002 0000 0000 0000 0000 0000 0030 003f 003f 003f
10: 003f 000f 0000 0030 003f 003f 003f 003f 000f 0000
20: 0000 0000 0003 0003 0004 0010
Table 1 Description on the fields of the display dsl configuration command
Field Description
Mode Operating mode, customer premises equipment (CPE) or
central office (CO)
Standard The supported standard
Annex Available options are a and b.
Wire Type Two-wire system or four-wire system.
Framing Framing format
SNR Threshold Signal to noise ratio threshold
Current Margin Current margin
SNEXT margin Worst-case margin