Filter
Top Products
2220 CHAPTER 145: BACKUP CENTER CONFIGURATION COMMANDS
Description Use the standby bandwidth command to configure the bandwidth available for
transmission on the main interface.
Use the
undo standby bandwidth command to restore the default.
By default, the available bandwidth used for setting the thresholds is 0 kbps.
Note that:
Use this command after backup interfaces are specified.
■ If the available bandwidth used for setting the thresholds is 0kbps (the default
value), the backup center automatically obtains the available bandwidth
provided by the system to set the thresholds. If the backup center fails to
obtain the physical bandwidth, it would prompt you to reconfigure.
■ If the available bandwidth configured for setting the thresholds exceeds the
physical bandwidth on the interface, the load balancing does not take effect.
Related command: standby interface
Example # Configure the available bandwidth used for setting the thresholds on the main
interface Serial 2/0 for load sharing to 10000 kbps.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] standby bandwidth 10000
standby interface
Syntax standby interface interface-type interface-number [ priority ]
undo standby interface interface-type interface-number
View Interface view
Parameter interface-type interface-number: Specifies an interface by its type and number.
priority: Specifies the priority of the backup interface, in the range 0 to 255. The
greater the value, the higher the priority. The default is 0.
Description Use the
standby interface command to specify a backup interface for the
current interface.
Use the
undo standby interface command to remove the specified backup
interface.
By default, no backup interface is specified.
Note that:
This command and the standby interface command cannot be configured at the
same time. That is, if you have configured the standby interface command on