Filter
Top Products
332 CHAPTER 20: DCC CONFIGURATION COMMANDS
display interface dialer
Syntax display interface dialer [ number ]
View Any view
Parameters number : Dialer interface number.
Description Use the
display interface dialer command to display the information about a
dialer interface. If you do not provide this argument, this command displays the
information about all the dialer interfaces.
Examples # Display the information about all the dialer interfaces.
<H3C> display interface dialer
Dialer1 current state: UP
Line protocol current state: UP (spoofing)
Description: Dialer1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is Dialer, baudrate: 64000 bps
Output queue : (Urgent queuing : Size/Length/Discards) 0/50/0
Output queue : (Protocol queuing : Length) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Enable Timer set by the dialer timer enable command
Idle Timer set by the dialer timer idle command
Wait-for-carrier Timer set by the dialer timer wait-carrier command
Total Channels Total number of channels on the interface
Free Channels Number of free channels
Table 31 Description on the fields of the display dialer command
Field Description
Table 32 Description on the fields of the display interface dialer command
Field Description
current state Physical state of a dialer interface (up/down)
Line protocol current state Data link layer protocol state of the dialer interface
(up/down)
Description Interface description
The Maximum Transmit Unit MTU of the dialer interface
Internet protocol processing Network layer protocol state of the dialer interface
(enabled/disabled)
Link layer protocol is PPP Current data link layer protocol