Filter
Top Products
55
BOOTP CLIENT CONFIGURATION
COMMANDS
n
■ BOOTP client configuration can only be used on Layer 3 Ethernet interfaces
(including sub-interfaces) and VLAN interfaces.
■ If several VLAN interfaces sharing the same MAC address obtain IP addresses
through a BOOTP relay agent, the BOOTP server cannot be a Windows 2000
Server or Windows 2003 Server.
■ You are not recommended to enable both the DHCP client and the DHCP
Snooping on the same device. Otherwise, DHCP Snooping entries may fail to
be generated, or the BOOTP client may fail to obtain an IP address.
c
CAUTION: The support for the DHCP Snooping function varies with devices.
display bootp client
Syntax display bootp client [ interface interface-type interface-number ]
View Any view
Parameter interface interface-type interface-number: Displays the BOOTP client information
of the interface.
Description Use the
display bootp client command to display related information about a
BOOTP client.
Note:
■ If interface interface-type interface-number is not specified, the command will
display information about BOOTP clients on all interfaces.
■ If interface interface-type interface-number is specified, the command will
display information about the BOOTP client on the specified interface.
Example # Display related information about the BOOTP client on Ethernet1/0.
<Sysname> display bootp client interface ethernet 1/0
Ethernet1/0 BOOTP client information:
Allocated IP: 169.254.0.2 255.255.0.0
Transaction ID = 0x3d8a7431
Mac Address 00e0-fc0a-c3ef