Filter
Top Products
1626 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS
View Tunnel interface view
Parameter None
Description Use the
mpls te loop-detection command to configure the node to perform
loop detection when setting up the MPLS TE tunnel.
Use the
undo mpls te loop-detection command to disable loop detection.
Loop detection is disabled by default.
Example # Configure the node to perform loop detection when setting up tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te loop-detection
mpls te max-link-bandwidth
Syntax mpls te max-link-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]
undo mpls te max-link-bandwidth
View Interface view
Parameter bandwidth-value: Maximum link bandwidth available for RSVP traffic, in the range
1 to 32000000 kbps.
bc1 bc1-bandwidth: Reservable bandwidth in kbps on the interface, in the range 1
to bandwidth-value.
Description Use the
mpls te max-link-bandwidth bandwidth-value command to
configure maximum link bandwidth.
Use the
undo mpls te max-link-bandwidth command to remove the
configuration.
The configured maximum bandwidth is available for both MPLS traffic and
common best-effort traffic.
Example # On interface Serial 1/0 set maximum link bandwidth available for RSVP traffic to
1158 kbps, and the reservable bandwidth to 200 kbps.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] mpls te max-link-bandwidth 1158 bc1 200
mpls te max-reservable-bandwidth
Syntax mpls te max-reservable-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]