Filter
Top Products
31
PPP AND MP CONFIGURATION
COMMANDS
display interface mp-group
Syntax display interface mp-group [ mp-number ]
View Any view
Parameter mp-number: Multilink point to point protocol group (MP-group) interface number,
which can be the number of any existing MP-group interface.
Description Use the
display interface mp-group command to view the information about
an existing MP-group interface. If the mp-number argument is not specified, the
information about all existing MP-group interfaces is displayed.
Example # View the information about the interface MP-group 12.
<Sysname> display interface mp-group 12
Mp-group12 current state: DOWN
Line protocol current state: DOWN
Description: Mp-group12 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is MP
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 82 Description on the fields of the display interface mp-group command
Field Description
current state Physical state of the interface (up or down)
Line protocol current state State of the data link layer protocol (up or down)
Description Description string of the interface
The Maximum Transmit Unit Maximum transmit unit (MTU) of the interface
Hold timer Hold time of the link state (up/down) of the current
interface
Internet protocol processing State of the network layer protocol (enabled or
disabled)