Filter
Top Products
404 CHAPTER 22: FRAME RELAY CONFIGURATION COMMANDS
Example # Set the bundle LID of the multilink frame relay bundle link Serial 2/0 to be bl1.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] mfr link-name bl1
mfr retry
Syntax mfr retry number
undo mfr retry
View Frame relay interface view
Parameter number: The maximum times that a bundle link can resend hello messages, in the
range 1 to 5.
Description Use the
mfr retry command to set the maximum times that a frame relay bundle
link can resend hello message when waiting for a hello acknowledgement
message.
Use the
undo mfr retry command to restore the default.
By default, the maximum times that a frame relay bundle link can resend hello
message is twice.
The bundle link sustains link status by periodically sending hello message to the
peer end. If the times that a bundle link resends hello message reach the
maximum without receiving acknowledgement from the peer, the system will
regard the link protocol on the bundle link to be malfunctioning.
Only after the link-protocol fr mfr command is used to associate a frame relay
bundle link interface with a frame relay bundle, can this command be configured.
Example # Set the bundle link Serial 2/0 to resend hello message for 3 times at most.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] mfr retry 3
mfr stateup-respond-addlink
Syntax mfr stateup-respond-addlink
undo mfr stateup-respond-addlink
View System view
Parameter None