Filter
Top Products
1335
protocol: Routing protocol, which can have any of the following values:
■ bgp: Specifies the BGP protocol
■ isis: Specifies the IS-IS protocol
■ ospf: Specifies the OSPF protocol
■ rip: Specifies the RIP protocol
process-id: Process number of the unicast routing protocol, in the range of 1 to
65535. This argument must be provided if IS-IS, OSPF or RIP is the specified unicast
routing protocol.
policy-name: Name of the multicast route match rule, a case sensitive string of up
to 19 characters.
rpf-nbr-address: IP address of the PPF neighbor.
interface-type interface-number: Specifies the interface type and number of an
RPF neighbor. The interface type must not be Ethernet, GigabitEthernet, Loopback
or Vlan-interface.
preference: Route preference, in the range of 1 to 255 and defaulting to 1.
order-number: Match order for routes on the same segment, in the range of 1 to
100.
Description Use the
ip rpf-route-static command to configure a multicast static route.
Use the
undo ip rpf-route-static command to delete a multicast static route
from the multicast static routing table.
By default, no multicast static route is configured.
Note that:
■ The arguments source-address { mask | mask-length }, protocol and
policy-name are critical elements in multicast static route configuration. The
variation of any of these three arguments results in a different configuration.
■ In the configuration, you can use the display multicast routing-table static
command to check whether the multicast static route information contains this
configuration. If you find a match, modify the corresponding fields without
changing the configuration sequence; otherwise, add a multicast static route.
■ When configuring a multicast static route, you cannot designate an RPF
neighbor by specifying an interface (by means of the interface-type
interface-number command argument combination) if the interface type of
that router is Ethernet, GigabitEthernet, Loopback or Vlan-interface; instead,
you can designate an RPF neighbor only by specifying an address
(rpf-nbr-address).
■ Because outgoing interface iteration may fail or the specified interface may be
in the down state, the multicast static route configured with this command
may fail to take effect. Therefore, we recommend that you use the display
multicast routing-table static command after you configure a multicast