Filter
Top Products
1258 CHAPTER 82: IPV6 BGP CONFIGURATION COMMANDS
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 route-limit 10000
peer route-policy (IPv6 address family view)
Syntax peer { group-name | ipv4-address | ipv6-address } route-policy route-policy-name
{ import | export }
undo peer { group-name | ipv4-address | ipv6-address } route-policy
route-policy-name { import | export }
View IPv6 address family view
Parameters group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
route-policy-name: Specifies route-policy name, a string of 1 to 19 characters.
import: Applies the routing policy to routes from the peer (group).
export: Applies the routing policy to routes to the peer (group).
Description Use the peer route-policy command to apply a routing policy to routes
incoming from or outgoing to a peer or peer group.
Use the
undo peer route-policy command to remove the configuration.
By default, no routing policy is specified for the peer (group).
Use of the peer route-policy command does not apply the if-match interface
clause defined in the routing policy. Refer to if-match interface on page 1200.
Examples # Apply the routing policy test-policy to routes received from the peer group test.
<Sysname> system-view
[Sysname] route-policy test-policy permit node 10
[Sysname-route-policy] if-match cost 10
[Sysname-route-policy] apply cost 65535
[Sysname-route-policy] quit
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test route-policy test-policy import
peer route-update-interval (IPv6 address family view)
Syntax peer { ipv6-group-name | ipv6-address } route-update-interval seconds