Filter
Top Products
1174 CHAPTER 77: RIP CONFIGURATION COMMANDS
Parameters process-id: RIP process number, in the range of 1 to 65535. The default is 1.
vpn-instance vpn-instance-name: Specifies a VPN instance name, a string of 1 to
31 characters.
Description Use the
rip command to create a RIP process and enter RIP view.
Use the undo rip command to disable a RIP process.
By default, no RIP process is enabled.
Note that:
■ If no VPN instance is specified, the RIP process will run under public network
instance.
■ You must create a VPN instance before you apply a RIP process to it. For related
configuration, refer to “ip vpn-instance” on page 1696.
■ You must create the RIP process before configuring the global parameters. This
rule does not apply to interface parameters.
■ The configured interface parameters become invalid after you disable the RIP
process.
Examples # Create a RIP process and enter rip process view.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1]
rip authentication-mode
Syntax rip authentication-mode { md5 { rfc2082 key-string key-id | rfc2453 key-string } |
simple password }
undo rip authentication-mode
View Interface view
Parameters md5: MD5 authentication mode.
rfc2453: Uses the message format defined in RFC 2453 (IETF standard).
rfc2082: Uses the message format defined in RFC 2082.
key-id: MD5 key number, in the range of 1 to 255.
key-string: MD5 key string with 1 to 16 characters in plain text format, or 1 to 24
characters in cipher text format. When the display current-configuration
command is used to display system information, a 24-character cipher string is
displayed as the MD5 key string.
simple: Plain text authentication mode.