Filter
Top Products
1908 CHAPTER 126: 802.1X CONFIGURATION COMMANDS
After a supplicant fails the authentication, the authenticator refuses further
authentication requests from the supplicant in the period dictated by the quiet
timer.
Related command: display dot1x, dot1x timer.
Example # Enable the quiet timer.
<Sysname> system-view
[Sysname] dot1x quiet-period
dot1x retry
Syntax dot1x retry max-retry-value
undo dot1x retry
View System view
Parameter max-retry-value: Maximum number of attempts to send an authentication request
to a supplicant, in the range 1 to 10. The default is 2.
Description Use the
dot1x retry command to set the maximum number of attempts to send
an authentication request to a supplicant.
Use the
undo dot1x retry command to restore the default.
By default, the authenticator can send an authentication request to a supplicant
for up to twice.
Note that after sending an authentication request to a supplicant, the
authenticator may retransmit the request if it does not receive any response at an
interval specified by the username request timeout timer or supplicant timeout
timer. The number of retransmission attempts is one less than the value set by this
command.
Related command: display dot1x.
Example # Set the maximum number of attempts to send an authentication request to a
supplicant as 9.
<Sysname> system-view
[Sysname] dot1x retry 9
dot1x supp-proxy-check
Syntax In system view:
dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]