Filter
Top Products
2595
Use the undo entity command to remove the existing voice entity.
In a global view, use the entity command to enter a voice entity view, and use
quit to return to the dial program view.
n
The entity-number assigned to a VoIP or POTS entity must be unique among all
VoIP and POTS entities.
Related command: line.
Example # Create and enter the voice entity view to configure a POTS voice entity whose
identification is 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
fast-connect
Syntax fast-connect
undo fast-connect
View VoIP entity view
Parameter None
Description Use the
fast-connect command to enable fast connection for H.323 calls.
Use the undo fast-connect command to disable fast connection.
By default, fast connection is disabled.
As there is no ability negotiation for fast connection mode, the ability confirmation
of the two parties is determined by the called gateway. When the router acts as an
originating gateway, you can set whether or not to apply fast connection mode for
each originated call. When the router acts as a terminating gateway, the
configuration of the voip called-start command will determine whether fast
connection is used for call initialization.
Fast connection procedure will be used when both the calling and called parties
support fast connection. Provided that neither the calling nor the called gateway
supports fast connection mode, the system will automatically switch to normal
connect procedure to resume the call.
It is OK to only configure fast-connect command for VoIP voice entity on the
calling gateway. Just after successfully enabling fast connection can the tunnel
function be configured.
Related command: outband, tunnel-on, and voip called-start.