Filter
Top Products
2655
value: 0 or 1. 0 indicates that DTMF detection is sensitive while “1” indicates that
DTMF detection is insensitive.
Description Use the dtmf threshold digital command to set the DTMF detection sensitivity.
Use the undo dtmf threshold digital command to restore the default DTMF
detection sensitivity.
By default, the DTMF detection is insensitive.
The more sensitive the DTMF detection is, the larger the tolerance of DTMF
collection is. The possibility of detecting error codes becomes relatively high while
the possibility of missing detecting error codes becomes low.
Example # Set the DTMF detection to be insensitive.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscirber-line1/0:0
[Sysname-voice-line1/0:0] dtmf threshold digital 1
final-callednum enable
Syntax final-callednum enable
undo final-callednum enable
View R2 CAS view
Parameter None
Description Use the
final-callednum enable command to enable the originating point to
send a number terminator to the terminating point after it sends all digits of a
called number. After the terminating point receives this terminator, it stops
requesting the called number.
Use the
undo final-callednum enable command to disable the originating
point to send a number terminator to the terminating point after it sends all digits
of a called number.
By default, no number terminator is sent.
This command applies to R2 signaling only.
You may configure the final-callednum command to accommodate to the R2
interregister signaling in some countries where a number terminator can be sent
to indicate that all digits of a called number has been sent.
Related command: register-value digital-end.
Example # Enable the originating point to send the number terminator signal.