Filter
Top Products
1708 CHAPTER 98: MPLS L3VPN CONFIGURATION COMMANDS
reflect between-clients
Syntax reflect between-clients
undo reflect between-clients
View BGP-VPNv4 subaddress family view/BGP-L2VPN address family view
Parameter None
Description Use the
reflect between-clients command to enable route reflection between
clients.
Use the
undo reflect between-clients command to disable the function.
By default, route reflection between clients is enabled.
If fully meshed interconnections exist between the clients, route reflection is not
required. Otherwise, an RR is required for routes to be reflected from one client to
every other client.
Example # In BGP-VPNv4 subaddress family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpnv4
[Sysname-bgp-af-vpnv4] undo reflect between-clients
# In BGP-L2VPN address family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] l2vpn-family
[Sysname-bgp-af-l2vpn] undo reflect between-clients
reflector culster-id
Syntax reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
View BGP-VPNv4 subaddress family view/BGP-L2VPN address family view
Parameter cluster-id: Cluster ID of the route reflector (RR), in the range 1 to 4294967295.
ip-address: IP address of the peer, which is to be used as the cluster ID of the RR.
Description Use the
reflector cluster-id command to specify a cluster ID for an RR.
Use the
undo reflector cluster-id command to remove the cluster ID.