Filter
Top Products
2487
Port Operating Status : on
Port IEEE Class : 1
Port Detection Status : delivering-power
Port Power Mode : signal
Port Current Power : 11592 mW
Port Average Power : 11610 mW
Port Peak : 11684 mW
Port Max Power : 15400 mW
Port Current : 244 mA
Port Voltage : 51.7 V
Port PD Description : IP Phone For Room 101
Table 640 Description on fields of the display poe interface ethernet command
Field Description
Port Power Enabled PoE enabled/disabled state
■ enable: PoE is enabled.
■ disable: PoE is disabled.
Port Power Priority Power priority of the PoE interface:
■ critical (highest)
■ high
■ low
Port Operating Status Operating state of a PoE interface:
■ off: PoE is disabled.
■ on: Power is supplied for a PoE interface normally.
■ power lack: The guaranteed remaining power of the PSE is
not high enough to supply power for a critical PoE interface.
■ power-deny: The PSE refuses to supply power. The power
required by the powered device (PD) is higher than the
configured power.
■ power-itself: The external equipment is supplying power for
itself.
■ power-limit: The PSE is supplying a limited power. The power
required by the PD is higher than the configured power and
the PSE still supplies the configured power.
■ Different models of device support different operating states.
Port IEEE class PD power class: 0, 1, 2, 3, 4, and -
The support for the - field depends on the device model.
Port Detection Status Power detection state of a PoE interface:
■ disabled: The PoE function is disabled.
■ searching: The PoE interface is searching for the PD.
■ delivering-power: The PoE interface is supplying power for the
PD.
■ fault: There is a fault defined in 802.3af.
■ test: The PoE interface is under test.
■ other-fault: There is a fault other than defined in 802.3af.
■ pd-disconnect: The PD is disconnected.
Different models of device support different detection states.