Filter
Top Products
2170 CHAPTER 141: IKE CONFIGURATION COMMANDS
Description Use the remote-address command to configure the remote IP address of the
IPSec tunnel.
Use the
undo remote-address command to remove the configuration.
Note that the ip-address configured with the remote-address command must
agree with the IP address configured with the local-address command.
Related command: id-type ip, local-address.
Example # Configure the remote IP address as 10.0.0.1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] remote-address 10.0.0.1
remote-name
Syntax remote-name name
undo remote-name
View IKE peer view
Parameter name: Name of the peer gateway for IKE negotiation, a string of 1 to 32
characters.
Description Use the
remote-name command to configure the name of the remote gateway.
Use the undo remote-name command to remove the configuration.
If the IKE negotiation initiator uses its gateway name for IKE negotiation (that is,
the id-type name command is configured on the initiator), it sends the name as
its identity to the peer, whereas the peer uses the gateway name configured with
the remote-name name command to authenticate the initiator. Therefore, the
local gateway name for a device must be identical to the remote gateway name
configured on its peer.
Related command: id-type, ike local-name.
Example # Configure the remote gateway name as apple for IKE peer peer1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] remote-name apple
reset ike sa
Syntax reset ike sa [ connection-id ]