Filter
Top Products
2434 CHAPTER 163: INFORMATION CENTER CONFIGURATION COMMANDS
info-center enable
Syntax info-center enable
undo info-center enable
View System view
Parameter None
Description Use the
info-center enable command to enable information center.
Use the
undo info-center enable command to disable the information center.
The system outputs information to the log host or the console only after the
information center is enabled first.
By default, the information center is enabled.
Example # Enable the information center.
<Sysname> system-view
[Sysname] info-center enable
% Information center is enabled
info-center logbuffer
Syntax info-center logbuffer [ channel { channel-number | channel-name } | size buffersize ]
*
undo info-center logbuffer [ channel | size ]
View System view
Parameter buffersize: Specifies the maximum number of log messages in a log buffer, in the
range 0 to 1,024 with 512 as the default value.
channel-number: A specified channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or one
that is defined by the user. The user needs to specify a channel name first before
using it as a self-defined channel name. For more information, refer to
“info-center channel name” on page 2432.
Description Use the
info-center logbuffer command to enable information output to a log
buffer and set the corresponding parameters.
Use the
undo info-center logbuffer command to disable information output
to a log buffer.