Filter
Top Products
1420 CHAPTER 90: PIM CONFIGURATION COMMANDS
Description Use the probe-interval command to configure the register probe time.
Use the
undo probe-interval command to restore the default setting.
By default, the register probe time is 5 seconds.
Related command: register-suppression-timeout (PIM view).
Example # Set the probe time to 6 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] probe-interval 6
register-policy (PIM view)
Syntax register-policy acl-number
undo register-policy
View Public instance PIM view, VPN instance PIM view
Parameter acl-number: Advanced ACL number, in the range of 3000 to 3999. Only register
messages that match the permit statement of the ACL can be accepted by the RP.
Description Use the
register-policy command to configure an ACL rule to filter register
messages.
Use the
undo register-policy command to remove the configured register
filtering rule.
By default, no register filtering rule is configured.
Related command: register-suppression-timeout (PIM view).
Example # In the public instance configure the RP to accept only those register messages
for multicast traffic from multicast sources in the range of 10.10.0.0/16 to
multicast groups in the range of 225.1.0.0/16.
<Sysname> system-view
[Sysname] acl number 3000
[Sysname-acl-adv-3000] rule permit ip source 10.10.0.0 0.0.255.255 d
estination 225.1.0.0 0.0.255.255
[Sysname-acl-adv-3000] quit
[Sysname] pim
[Sysname-pim] register-policy 3000
register-suppression-timeout (PIM view)
Syntax register-suppression-timeout interval