Filter
Top Products
1124 CHAPTER 76: OSPF CONFIGURATION COMMANDS
display ospf peer
Syntax display ospf [ process-id ] peer [ verbose | [ interface-type interface-number ]
[ neighbor-id ]]
View Any view
Parameters process-id: OSPF process ID, in the range 1 to 65535.
verbose: Displays detailed neighbor information.
interface-type interface-number: Interface type and number
neighbor-id: Neighbor router ID.
Description Use the
display ospf peer command to display information about OSPF
neighbors.
Note that:
If no OSPF process is specified, OSPF neighbor information of all OSPF processes is
displayed.
If an interface is specified, the neighbor on the interface is displayed.
If a neighbor ID is specified, detailed information about the neighbor is displayed,
If neither interface nor neighbor ID is specified, brief information about neighbors
of the specified OSPF process or all OSPF process is displayed.
Examples # Display detailed OSPF neighbor information.
<Sysname> display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.1
Neighbors
Area 0.0.0.0 interface 1.1.1.1(Ethernet0/1/0)’s neighbors
Router ID: 1.1.1.2 Address: 1.1.1.2 GR State: Normal
State: Full Mode: Nbr is Master Priority: 1
DR: 1.1.1.2 BDR: 1.1.1.1 MTU: 0
Dead timer due in 33 sec
Neighbor is up for 02:03:35
Authentication Sequence:[0]
Neighbor state change count: 6
Table 271 Description on the fields of the display ospf peer verbose command
Field Description
Area Area of the neighbor
Interface Interface connected to neighbor
Router ID Neighbor router ID
Address Neighbor router address
GR State GR state